| After-sales Service: | Following Updating |
|---|---|
| Warranty: | Under Discussion |
| Weighing: | 5000kg |
|
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| specifications |
| Power supply voltage AC power supply 180-240 V AC 50/60 Hz |
| Consumption power AC power 20VA (including optional functions) |
| The allowable voltage variation range is 90%~110% of the power supply voltage |
| Power frequency with an allowable interruption time of less than 1 week |
| Insulation resistance ≥ 100M Ω (500V DC MEGA reference) |
| Insulation strength 2000V AC (test conditions: 50/60Hz, 1 minute) |
| Anti interference IEC61000-4-2 (electrostatic discharge), Class III |
| IEC61000-4-4 (Electrical Fast Transient Pulse Group), Class III |
| IEC61000-4-5 (surge), Class III |
| The operating environment temperature is -20 ºC~50 ºC, avoiding direct sunlight, and the temperature change rate is less than 10 ºC/h |
| Environmental humidity of 20% to 80% RH (temperature of 5-40 ºC), |
| 10%~50% RH (temperature 40-50 ºC), no condensation |
| Installation location indoor, height < 2000m, maximum tilt back 30 °, left and right horizontal |
| Display specifications |
| Display a 3.2-inch TFT color LCD screen (320 x 240 dots) |
| Brightness level can be set: 70% to 100% |
| If there is no key operation within the specified time, the LCD backlight will dim. |
| Storage/Dump Specifications |
| Internal memory capacity 64Mbit |
| Data dump media USB drive |
| Data Dump Protocol USB 1.1/2.0 Protocol |
| The maximum capacity of a USB flash drive is 32GB |
| USB file system FAT16 or FAT32 |
| Input specifications |
| The input channel number instrument supports up to 2 channel boards, totaling 16 measurement channels |
| Measurement cycle of 0.1 seconds |
| Basic error * ± 0.2% F · S |
| Isolate the measurement channels within the same channel board without isolation, and isolate between different channel boards. |
| Optional accessory specifications |
| currency |
| function |
| P-zone general alarm D1 2-point alarm relay output, |
| Both are normally open and normally closed dual contacts 250V AC/3A |
| Resistive load |
| D2 cannot be selected when expanding KA function |
| D2 8-point alarm relay output, |
| Both are normally open and normally closed dual contacts |
| D3 8-point alarm relay output, |
| All are normally open single contacts |
| extend |
| function |
| B area expansion input KI 8-way input |
| Extended transmission KA 8-channel transmission output (4-20) mA output, photoelectric isolation, |
| Resolution: 1/10000, load capacity: 600 Ω |
| Expansion alarm KT 8-point alarm relay output, |
| Both are normally open and normally closed dual contacts 250V AC/3A |
| Resistive load |
| communication |
| Interface MS1 RS232C interface photoelectric isolation, |
| Response time: less than 500 μ S (measured value) |
| Communication protocol selected through software |
| (TCASCII or Modbus RTU) |
| MS2 RS485 interface |
| The printing interface of MS3 RS232C interface is RS232. Connected to a micro printer |
){kind=link}