| After-sales Service: | Following Updating |
|---|---|
| Warranty: | Under Discussion |
| Switching Power Supply: | DC24V |
|
Still deciding? Get samples of US$ 300/Piece
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Internal Wire Terminal Identification | "EX+" Sensor's positive bridge power supply terminal |
| "EX-" Sensor's negative bridge power supply terminal | |
| "SN+" Sensor's sense power positive terminal | |
| "SN-" Sensor's negative inductive power supply | |
| "SlG+" sensor output signal positive terminal | |
| "SIG-" negative end of the sensor's output signal | |
| "GND" shielding layer of the shielding cable | |
| Junction box adjustment method | Precision potentiometer VR1~VR4 can be used to fine-tune the output signals of each sensor respectively for the adjustment of the four corners of the system. Four-way dip switches SW1~SW4 are used to disconnect or connect the corresponding sensors, when they are in OFF position, the sensors are disconnected from the system; when they are in ON position, the sensors are connected to the system. |
| Differential adjustment method | Step 1: Turn all four potentiometers to the center position before adjustment. |
| Step 2:Observe and record the millivolt signals transmitted by each sensor individually through the dip switch (when observing one of them, turn off the other three). | |
| Step 3: the deviation of the larger one way to the four-way average fine-tuning (observation of which 1 way, to close the other 3 ways). | |
| Step 4: Repeat step 2 and step 3 until the four-way millivolt signal is similar. |
){kind=link}